The article discusses the process of installing a new window and door opening from a bedroom onto a deck. It emphasizes the importance of proper planning and safety measures when adding a window or door to a load-bearing wall. The article begins by removing the existing window trim and conducting an electrical inspection. The article then outlines the steps to replace a window with a door, including outlining the wall in chalk, marking the location of doors or windows, and locating top and bottom sill plates for studs. The article also suggests that completing all framing before cutting the window out of the sheathing or drywall can help reduce dust. The article also mentions the need to move one of the large windows about 3 feet down the wall to allow for the slider to be installed in the correct place symmetrically. The article also mentions the importance of considering whether the wall is load-bearing or contains essential pipes or wiring that cannot be cut. The article concludes by mentioning that it can be challenging to find windows or doors that will properly align to the correct location within the wall section.
📹 How to Relocate a Window in an Existing Wall
Installing windows in an existing opening is a fairly straightforward practice. First, consider the structural load of the relocated …
📹 How to Install a Window in an existing block wall.
I created this video with the YouTube Video Editor (http://www.youtube.com/editor)
good article, #5 rebar is required in the sill with usually a 6in overlap. and Rebar may or may not be required in the lintel depending on the dimensions of the window and how close it is to the tie beam. Depending on if the house is in a high velocity hurricane zone, there may be other requirements as well to meet Florida building code. If the window is less than 2ft wide, no rebar is required normally. the window is attached to buck boards which are anchored to the sides and top of the concrete